Menu
Call: 800-338-7268 , 401-781-7800
For A Durant specialist And Lowest Instant Prices
Productivity Performers
To make sure your production facility can take advantage of the precision control and high speed effectiveness of the Durant Air Feed, we make 75 different models. If you are making something small in metal, plastic or paper, look to our A-50. This unit offers a 2" maximum width, a 2" maximum stroke, a .079" maximum thickness, and can operate at speeds up to 270 strokes per minute. Of course, that is just where things start out. Where they end up is the Maxi Model TK3 which handles width up to 24", with a maximum stroke of 12" , a maximum thickness of .100", and offers delivery capability of up to 40 units a minute. Every production need in between is covered. When you look at Durant, you will be looking at a number of special features you are not likely to find anywhere else. All units are built with extra thick wear plates, dual air cushions, hardened heavy duty guide rails, and hardened brass cylinder liners. To make your coil feeding even better, Durant Air Feeds come with a complete line of accessories. Each is designed to do its job perfectly ... each is designed to work perfectly with your Durant unit.
Unique Features Found on all Durant Models
|
Selection Versatility Comparison Construction Installation |
Accuracy Productivity Performers |
Now you can feed materials from .002" to .200" thick. And widths as wide as 24". With 75 models available, Durant has a model just right for your application.
Durant is built to see you through thick or thin, narrow or wide, flimsy or rigid, in metal, plastic or paper. Cost effective production always starts with Durant...and ends at the bottom line.
Put our Durant Air Feed units beside any other comparative unit you have heard about. We won't need to say anything more.
Every model in the line from standard to maxi is heavily constructed and totally sealed to insure trouble free operation, even in the most hostile factory environments.
Installation is a snap with Durant. Simply insert two bolts through mounting holes (standard air feed spacing), and bolt it to the press table or bolster plate. Next, fix a striker to the press ram and connect the air supply, (75 to 120 PSI). The second the striker is touched by the actuator on the feed, the feed goes into action. The feed length can be altered at any time by simply adjusting the stop on the air feed.
Our sophisticated series of controls enables Durant to achieve accuracy of 0.001" for a couple of reasons. First of all, the feed material is always in the solid grip of either the feed clamp or the holding clamp so it cannot slip or misfeed. Secondly, even if it is maladjusted, the special shock absorbing air cushions at each end of the stroke prevent bounce.
To make sure your production facility can take advantage of the precision control and high speed effectiveness of the Durant Air Feed, we make 75 different models. If you are making something small in metal, plastic or paper, look to our A-50. This unit offers a 2" maximum width, a 2" maximum stroke, a .079" maximum thickness, and can operate at speeds up to 270 strokes per minute. Of course, that is just where things start out. Where they end up is the Maxi Model TK3 which handles width up to 24" , with a maximum stroke of 12" , a maximum thickness of .100", and offers delivery capability of up to 40 units a minute. Every production need in between is covered. When you look at Durant, you will be looking at a number of special features you are not likely to find anywhere else. All units are built with extra thick wear plates, dual air cushions, hardened heavy duty guide rails, and hardened brass cylinder liners. To make your coil feeding even better, Durant Air Feeds come with a complete line of accessories. Each is designed to do its job perfectly ... each is designed to work perfectly with your Durant unit.